Integral capacitors (IC) of one or two-layer printed wiring board (PWB) circuits were produced using comb electrodes fixtures and dielectric composites as the inter-electrode material. ICs were fabricated at laboratory scale, using copper comb electrodes and BaTiO3-epoxy composite materials deposited on a glass-Epoxy FR4 board. They were experimentally tested in order to obtain their electrical response. Furthermore, ICs behaviour was modelled through 2-dimensional models applying finite element method (FEM). Results showed that by this laboratory technique it was possible to obtained integral capacitors with low dielectric losses. Moreover, acceptable agreement was found between numerical and experimental capacitance results for all the different analysed ICs. In conclusion, 2D FEM models are a suitable tool to predict electric response of IC devices.

The dielectric behavior of composite materials (epoxy resin - barium titanate and epoxy - CCTO) was analysed as a function of ceramic amount. Composites were prepared by mixing the components and pouring them into suitable moulds. In some compositions, the matrix was reduced by tetrahydrofuran (THF) incorporation. Samples containing various amounts of ceramic filler were examined by TG/DTA and scanning electron microscopy analysis. Dielectric measurements were performed from 20 Hz to 1 MHz and 30 to 120 °C. It was demonstrated that the epoxy - CCTO composites possessed higher permittivity than classic epoxy - BaTiO3 composites. However, the low resin permittivity prevailed in the composite dielectric performance.